|
|
| Stone-Coated Steel Shingle |
| Installation
Guide |
|
|
Page 2 - Preparing The Install Stone-Coated Steel Shingles
|
 |
KBS Stone-Coated Steel
Shingles can be installed over low-profile composition
shingle, or over solid sheathing with a minimum type 30
felt underlayment. If you choose to re-roof over
lower profile composition shingles, the procedures are
as follows:
1) Cut back existing shingles flush with the perimeter of
the roof.
2) Remove existing drip edge.
3) Remove hip and ridge cap
4) Use a chalk line when installing the starter
strip. Do not depend on the roof edge to be
straight or square. Nail starter strip every
16" along the fascia line.
|
|
|
|
Cut back existing shingles
|
FASCIA STARTER STRIP
 |
|
Rake / Roof To Wall And Felt |
5) After installing the starter strip,
install the 1½" x 1½" Two-Way Metal up
the gable or rake ends, taking care to overlap the top
of the starter strip.
6) Wrap the entire roof with Type 30# Felt. Lay an
additional layer up the valley, spacing it equally on
both sides.
7) Install the Rake / Roof to Wall accessory piece up
the rake or gable end on top of the Two-Way Metal,
extending approximately 1" over the edge of the
rake or gable end. |
|
|
|
Ensure that the Rake / Roof to Wall overlaps
the Starter Strip.
|
|
|
Valley Preparation
|
8) Install standard clips along length of valley to hold
valley in place. DO NOT NAIL THROUGH VALLEY!
|
NOTE: Location of valley at edge of fascia should be at the
beginning of the first inside flutes of the valley,
|
|
|
